DeWalt DW530 Manual De Instrucciones página 6

154728-01 rev 9/10/02 2:23 PM
FIG. 3
TOOL
HOLDER
RETAINING
PIN BUTTON
FIG. 4
LOCKING
SLEEVE
All manuals and user guides at all-guides.com
Page 3
3
Motor
Your tool is powered by a D WALT built motor. Be sure your power
E
supply agrees with nameplate marking.
Voltage decrease of more than 10% will cause loss of power and
overheating. All D WALT tools are factory tested; if this tool does not
E
operate, check the power supply.
Side Handle and Depth Rod
For operating convenience, the side handle can be installed in front
or rear positions. Always operate the tool with the side handle
properly assembled.
TO MOUNT IN FRONT POSITION (FIG. 1)
1. Unscrew the side handle and disassemble the side handle clamp.
2. Snap the steel ring over the collar behind the tool holder. Squeeze
both ends together, mount the bush and insert the pin.
3. Place the side handle clamp and screw on the clamp knob. Do not
tighten.
4. Insert adjustable depth rod into hole.
5. Screw the side handle into the clamp knob and tighten it.
6. Rotate the side handle mounting assembly to the desired position.
For drilling horizontally with a heavy drill bit, place the side handle
assembly at an angle of approximately 20˚ for optimum control.
7. Lock the side handle mounting assembly in place by tightening the
clamp knob.
TO MOUNT IN REAR POSITION (FIG. 2)
1. Unscrew the side handle and remove it from the front position.
Leave the side handle mounting assembly in front position so that
the depth adjustment rod can still be used.
2. Screw the side handle directly into one of the rear side handle
positions on either side of the tool.