Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ZONE A SETUP
Press s
to cycle through the following
options: Zone A Setup; Zone A Output
Schedule; Zone B Setup; Zone B Output
Schedule; and System Setting.
NOTE:
All settings must be saved by
pressing
for the controller to operate.
Pressing twice will take you back to
the ENVIRONMENT CONDITIONS home
screen. 45 seconds of inactivity will
automatically revert to home screen.
1. Press
and enter the ZONE A menu.
2. Press
to cursor through the values and highlight the value you want to change.
Press
or
to select the correct setting, then press
Ensure zone Status is set to "OFF" prior to the initial time OUTPUT SCHEDULE programming
on Zone setup.
Value
Description
Type
Type of lights installed in ZONE A (or B): 1000W MH, 1000W CMH, 1000W HPS,
945W CMH, 750W MH, 750W HPS, 630W CMH, 600W X 2 HPS, 600W X 2 MH,
600W MH, 600W HPS, 400W MH, 400W HPS, 315W x 2 CMH, 315W CMH, 250W
MH, 250W HPS, 680W LED, 640W LED, 600W LED, 480W LED, 320W LED
Status Indicates current fixture wattage or percentage according to photo period timer
(OUTPUT SCHEDULE). User can manually override timer to adjust output if
needed and the W or % will be followed by "OVRD". Fixtures will revert to timer
schedule once next output time/setting is reached. Example: If manual override
is adjusted from 100% down to 60% at 7:45 PM, the display will be "Status: 60%
OVRD" and will remain until the next "OUTPUT" signal is sent by the controller. If
"OUTPUT" at 8:00 PM is scheduled to send 100% signal, the fixture will revert to
timer schedule.
Dim
The temperature limit at which the lights will auto-dim.
Stop
The temperature limit at which the lights will auto-shutdown.
Delay
(0–30 min) Hot start prevention to allow HID lamps adequate time to cool to
prevent lamp damage. For HID, minimum setting should be 15 min. For LED,
setting can be 0 min.
R/S
(0–30 min) The time lights will take to gradually reach full power (R=sunrise) or
turn off (S=sunset). Longer is more gradual. This setting will affect the OUTPUT
SCHEDULE. See page 6 for more details.
3. Repeat step 2 to set all values.
4. Press
to save the settings.
5. Repeat steps for ZONE B.
INSTRUCTIONS
to confirm.
5
Publicidad
Tabla de contenido
