auna UltraSonic Pulse V6-40 Manual De Instrucciones página 19

TWS operation
If you have two units of this model, you can connect the two units by TWS
function to become stereo output.
1. Connect the device to one of the units by Bluetooth function, this unit
will become the master unit.
2. Turn on the second unit and switch to Bluetooth mode, press and hold
the "LIGHT/TWS" button on the master unit, then these two units will
connect automatically with a sound indicated that the connection is
done. The master unit will show "tS R" and the second unit will show
"tS L", then these two units will become stereo output.
3. Control of play, pause, next track and previous track can be done by
both units. Rotate the volume knob on each unit to adjust the volume
individually.
4. To quit the TWS, press and hold the PLAY/PAUSE/PAIR button on the
second unit to disconnect.
AUX-IN
1. Press the FUNCTION button on unit to select "AUX" mode.
2. Connect your audio device to the AUX IN jack found on the front of the
unit with an AUX IN cable.
3. Rotate the VOLUME knob on the unit or adjust the volume on the
external device to increase or decrease the music volume to your desired
level.
4. Control playback with your audio device.
Mic jack operation
Microphone input is available in all modes.
1. Connect your microphone to the 6.3mm MIC JACK found on the front of
the unit.
2. Rotate the MIC VOL. knob on the unit to increase or decrease the
microphone volume
Guitar jack operation
Guitar input is available in all modes
1. Connect your guitar to the 6.3mm Guitar JACK found on the front of the
unit.
2. Rotate the GUITAR VOL. knob on the unit to increase or decrease the
guitar volume.
EN
19