Flex CHE 2-26 18.0-EC Instrucciones De Funcionamiento Originales página 18

Battery state of charge
 Press the button to check the state of
charge at the state of charge indicator
LEDs.
The indicator goes out after 5 seconds.
If one of the LEDs flashes, the battery must
be recharged. If none of the LEDs light up
after the button is pressed, the battery is
faulty and must be replaced.
Adjusting the auxiliary handle
WARNING!
Remove the battery before carrying out any
work on the power tool.
CAUTION!
Use the power tool with the attached
auxiliary handle only.
The auxiliary handle can be swivelled into
any position to ensure safe and fatigue-free
working.
NOTE!
With the depth stop attached, the pivot
range of the auxiliary handle is restricted.
 Release the clamping by turning the
auxiliary handle counterclockwise (1.).
 Swivel the auxiliary handle into the
desired position (2.).
 Secure the adjustment by turning the
auxiliary handle clockwise.
18
Attaching the depth stop
WARNING!
Remove the battery before carrying out any
work on the power tool.
 Press and hold clamping lever on
auxiliary handle in upper area (1.).
 Push in the depth stop (2.).
 Set depth stop to the required drilling
depth.
 Release clamping lever.
NOTE!
Push tool with SDS-plus shank in the
SDS-plus tool holder as far as the back
position. The movement of the tool could
otherwise result in an incorrect drilling depth
setting.
Inserting tools with SDS-plus shank
WARNING!
Remove the battery before carrying out any
work on the power tool.
CAUTION!
Used cutting accessories may become hot.
Wear protective gloves!
NOTE!
Tools used must have an SDS-plus shank.
If tools do not have an SDS plus shank
(e.g. wood drill bit), a keyless chuck must be
used.
 Check the dust cap.
– Clean the cap if dirty.
– Have a defective dust cap replaced.
CHE 2-26 18.0-EC