Troubleshooting; Product Maintenance - HAMPTON BAY 879-678 Manual De Instrucciones

TROUBLESHOOTING:

Possible Cause
Bulb will not turn on. 1. Bulb is burned out
2. Power is off.
3. Faulty wire connection.
4. Faulty switch.
Fuse blows or circuit breaker 1. Crossed wires or power wire is grounding
trips when light is turned on. out.

PRODUCT MAINTENANCE:

1. To clean the outside of the fixture, use a dry or slightly dampened clean cloth (use
clean water, never a solvent) to wipe the glass and surface of the fixture.
2. To clean the inside of the fixture, first disconnect power to the fixture by turning off
the circuit breaker or by removing the fuse at the fuse box. Next, use a dry or
slightly dampened clean cloth (use clean water, never a solvent) to wipe the inside
glass and interior surface of the fixture.
3. Do not use any cleaners with chemicals, solvents or harsh abrasives. Use only a dry
soft cloth to dust or wipe carefully.
LIMITED WARRANTY
The manufacturer warrants this lighting fixture to be free from defects in materials and
workmanship for a period of three (3) years from date of purchase. This warranty
applies only to the original consumer purchaser and only to products used in normal use
and service. If this product is found to be defective, the manufacturer's only obligation,
and your exclusive remedy, is the repair or replacement of of the product at the
manufacturer's discretion, provided that the product has not been damaged through
misuse, abuse, accident, modifications, alterations, neglect or mishandling.
warranty shall not apply to any product that is found to have been improperly installed,
set-up, or used in any way not in accordance with the instructions supplied with the
product. This warranty shall not apply to a failure of the product as a result of an
accident, misuse, abuse, negligence, alteration, or faulty installation, or any other failure
not relating to faulty material or workmanship. This warranty shall not apply to the
finish on any portion of the product, such as surface and/or weathering, as this is
considered normal wear and tear. The manufacturer does not warrant and specially
disclaims any warranty, whether expressed or implied, of fitness for a particular
purpose, other than the warranty contained herein. The manufacturer specifically
disclaims any liability and shall not be liable for any consequential or incidental
loss or damage, including but not limited to any labor/expense costs involved in the
replacement or repair of said product.
Page 8
Corrective Action
1. Replace light bulb.
2. M ake sure power supply is on.
3. Check wiring.
4. Test or replace switch.
1. Check wire connections.
This
MANUEL D'INSTALLATION
LANTERNE MURALE D'EXTÉRIEUR
Home Depot UGS n° 879-678 (CUP nº 046335947191)
Page 17