Getting Started; Explosion Protection - Softing mobiLink Guía De Inicio

Getting started

EN
Read this quick guide before you unpack and install mobiLink.
Scan the QR Code on the back page to download the related
User Guide before you operate the device.
Unpacking your mobiLink
1. Take the device and the accessory parts out of the box
and save the box and packing material.
2. Verify that the following items are contained
undamaged:
✓
mobiLink device
✓
USB cable (2m)
✓
red and black testing cables with clamp
✓
3 AA batteries
Setting up your mobiLink
1. Download the MOBILINKdtm or the Communication
Configuration Tool from the product website depending
on your use case (scan the QR code).
2. Double-click the setup file to start the installation.
3. Select the installation language.
4. Follow the install wizard instructions.
5. Read the User Guide available for download.
Startup and Operation
Do not open the battery compartment in
potentially hazardous areas.
Insert the batteries, switch on mobiLink and wait 5 seconds
until the device has started. The operation of mobiLink
requires the use of management tools like FDT frame
applications or configuration tools on Windows PCs or tablets
or smartphones.
See the User Guide for safety requirements and details on
how to set up a USB and Bluetooth communication and how
to configure the fieldbus and HART connection.
During startup mobiLink tries to verify the operation mode
against the connected fieldbus. If fieldbus terminals are
connected to an operating 4-20 mA link this will compromise
the analog process value. Make sure to use the correct
connections and mode.
Safety
mobiLink must be operated by qualified personal only. To
ensure the safety of personnel and equipment, mobiLink
must be used as intended and in accordance with local laws
and regulations. See also the User Guide for safety
requirements and regulations.
Ensure that the electrical parameters of mobiLink
match the fieldbus installation. Do not use a USB
connection to your host device in hazardous areas.
4
Transport and Maintenance
Remove the batteries for transport from the device to ensure
that mobiLink is mechanically secured against being switched
on inadvertently. Periodically wipe the housing with a damp
cloth. Do not use abrasives or solvents. Do not clean the device
inside hazardous areas! mobiLink does not contain user
serviceable parts. No modifications or repair on the device are
allowed.

Explosion protection

mobiLink has been developed for use in hazardous areas,
classified as Zone 1/Zone 2. It is approved for explosion group
IIC and temperature Class T4. Make sure that you use mobiLink
only in compliance with local safety requirements for
installation of electrical equipment in explosive atmospheres.
See the User Guide for details.
Use only approved batteries of type Energizer E91
or Duracell Procell MN1500. The use of a non-
approved battery type will void the Ex approval. Do
not use the USB interface in potentially hazardous
areas!
EU declaration of conformity
This product meets all requirements of the following applicable
EU Directives and harmonized standards.
▪ 2014/30/EU "EMC"
▪ 2011/65/EU "RoHS"
Bluetooth
This product has been tested and approved for Bluetooth
wireless communication in the following regions and countries:
▪ EU
▪ Japan
▪ South Korea
▪ USA
Certification of conformity
This product is IECEx and ATEX certified and was found to
comply with the standards and requirements indicated by the
following marks:
▪ 2014/34/EU "ATEX"
▪ 2014/53/EU "RED"
▪ Russia
▪ India
▪ UAE
▪ Canada