Level Control - Behringer MINIFBQ FBQ800 Manual Del Usuario

14
MINIFBQ FBQ800
MINIFBQ FBQ800 Controls
Controls
(EN)
(4) (2)
(3) (5) (6)
FBQ800 front panel
(POWER) button: To turn the FBQ800 on and off, use
(1)
this button, pushed in and illuminated: The FBQ800 is on.
Not pushed in and not illuminated: The FBQ800 is off.
IN/OUT button: To activate or, alternatively deactivate
(2)
control elements, use this button, pushed in and
illuminated: The FBQ800 activates all control elements.
Not pushed in and not illuminated: The FBQ800 deactivates
most control elements. However, you can use the METER
SELECT button and the IN/OUT meter
(5)
LEVEL CONTROL: To adjust the level of the input signal,
(3)
turn this control toward -12 dB (minimum setting) or,
alternatively +12 dB (maximum setting).
LOW CUT button: To manage the low-cut filter, use this
(4)
button, pushed in and illuminated: The low-cut filter
eliminates sounds that are below 75 Hz (floor rumble, room
resonance, and mains hum, for example). Not pushed in
and not illuminated: The low-cut filter does not eliminate
any sounds.
METER SELECT button: To select the type of signal you
(5)
want to monitor, use this button, pushed in and illuminated:
Monitor the input signal as soon as this signal enters the
FBQ800. The FBQ800 does not apply the LEVEL control or any
other control elements to the input signal that you monitor.
Not pushed in and not illuminated: Monitor the output
signal as soon as this signal leaves the FBQ800. The FBQ800
applies all control elements to the output signal that you
monitor. However, if you deactivated most of the control
elements , the input signal and the output signal
(2)
are the same.
(9)
IN/OUT METER: To monitor the level of the signal that you
(6)
selected with the METER SELECT button, use this stereo
meter. Both the left (L) and right (R) sides of this meter
share the same decibel scale (-24 dB to +6 dB). If the signal
level is too high, the CLIP LED illuminates.
RANGE button: To select a range for the EQ faders, use this
(7)
button, pushed in and illuminated: The fader range extends
from -6 dB to +6 dB. Not pushed in and not illuminated:
. The fader range extends from -12 dB to +12 dB.
(6)
FBQ IN button: To manage the FBQ Feedback Detection
(8)
System, use this button, pushed in and illuminated: The
FBQ Feedback Detection System is activated. If the signal
level is high in a frequency band, the relevant fader LED
illuminates brightly. In addition, all other fader LEDs are
dimmed. To reduce the potential for feedback, cut the signal
in the relevant frequency band
illuminated: The FBQ Feedback Detection System is not
activated. Fader LEDs illuminate with identical brightness.
They do not identify possible feedback frequencies.
EQ SECTION: If you activated all control elements
(9)
the input signal travels to the EQ section.
(8)
(7) (1)
. Not pushed in and not
(9)
,
(2)