Assembly Instructions; Storage/Shoe Bench Use Requirements; Storage/Shoe Bench Parts; Tools And Parts - Gladiator GAGB54SBJG Instrucciones De Ensamblaje

Storage/Shoe Bench Use
Requirements
Intended for use in a garage.
■
Maximum weight limit is 35 lbs (15.9 kg) for each shelf.
■
Maximum weight limit is 500 lbs (227 kg) for the hardwood
■
storage/shoe bench.

Storage/Shoe Bench Parts

1. Remove and verify the contents. Contents include the parts
and fasteners shown in "Parts."
2. Dispose of/recycle all packaging materials.

Tools and Parts

Gather the required tools before starting installation.
Tools Needed:
1/2" wrench
■
Phillips-head screwdriver
■
Level
■
WARNING
Excessive Weight Hazard
Use two or more people to move, assemble or install
cabinet.
Failure to do so can result in back or other injury.
IMPORTANT:
Two people may be required to complete the assembly.
■
The hardwood top (P2) is intentionally designed so that the
■
heads of the lag bolts which were pre-assembled on the
hardwood top (P2) will match with the key holes on the side
panel (P3 and P1) only when it is positioned correctly. If the
bolt heads on the hardwood top (P2) do not match with the
key holes on the side panel (P3 and P1), turn the hardwood
top (P2) around.
1. Place the hardwood top (P2) on floor (upside down, with the
protruding lag bolt heads pointing upward).
2. Assemble the left side panel (P1). Place the panel
perpendicular to workbench top, making sure to align the key
holes in the panel with the pre-assembled lag bolts in the top.
3. Use a wrench to tighten the two lag bolts [which were
pre-assembled onto the hardwood top (P2)]. Fully tighten the
bolts.
P3
4. Repeat above steps 2 and 3 for the other cabinet side.
4

ASSEMBLY INSTRUCTIONS

P1
P2

Attach Back Panels

F1
#10-24 x 1/4"
long Phillips-head Screw (2)
1. Slide in the back panel (P5) so that the tabs in the back
panel are aligned with the slots of the side panels. There are
two tabs on each side of the panel (See detail to illustration
below).
2. Push in and ensure the four tabs are fully engaged in the slots.
3. Attach the four #8 x 1/2" long Phillips-head screws (F3) to the
hardwood top (P2).
4. Attach the two #10-24 x 1/4" long Phillips-head screws (F1)
between the side panels (P3 and P1) and back panel (P5). Do
not fully tighten the screws. This will be done later.
P1
F1
P2
F1 #10-24 x 1/4" long Phillips-head screw (2)
F3 #8 x 1/2" long Phillips-head screw (4)
F3
#8 x 1/2"
long Phillips-head screw (4)
P3
F1
P5
F3