Assembly Instructions; Tools And Parts; Cabinet Use Requirements; Unpack Cabinet Parts - Gladiator GAJG48KDYG Instrucciones De Ensamblaje

Tools and Parts

Gather the required tools and parts before starting installation.
Tools Needed:
1/2" Wrench
■
3/8" Wrench
■
Tools Supplied:
Hex key
■

Cabinet Use Requirements

Intended for use in a garage.
■
Maximum weight limit is 50 lbs (22.7 kg) for each shelf.
■
Maximum weight limit is 250 lbs (113.6 kg) for the cabinet.
■
Unpack the Cabinet
1. Remove and verify the contents. Contents include a hex key, a
key, and the parts and fasteners shown in "Parts."
2. Dispose of/recycle all packaging materials.

ASSEMBLY INSTRUCTIONS

Phillips screwdriver
■
Level
■
Key
■

Assemble Cabinet

WARNING
Excessive Weight Hazard
Use two or more people to move, assemble or install
cabinet.
Failure to do so can result in back or other injury.
IMPORTANT: Two people may be required to complete the
assembly. As you assemble the cabinet, make sure the edges
with the holes are facing up. If you are assembling the cabinet on
the floor, fasten the eight front corner bolts, two at each corner,
after you stand the cabinet upright.
1.
Assemble Cabinet
F1
F1
F1 5/16" hex-head bolt (24)
F2 5/16" flange nut (8)
P1
P3
Place side panel (P1) on a flat, firm surface so that the edge
with the holes is facing up as shown. Insert the cabinet top (P2)
between the edges of side panel (P1).
NOTE: Make sure the edges with the holes are facing up.
Align the holes and attach the top (P2) to side panel (P1) using six
Hex-head bolts (F1) and two 5/16" flange nuts (F2) as shown.
Do not tighten completely. Position the other side panel (P1) so
that the top (P2) is between the edges of side panel (P1). Align the
holes and attach the top (P2) to the side (P1) using six Hex-head
bolts (F1) and two 5/16" flange nuts (F2) as shown. Do not tighten
completely. Insert the cabinet bottom (P3) between the edges of
the side panels (P1).
NOTE: Make sure the edges with the holes are facing up.
Align the holes and attach the bottom (P3) to the sides (P1) using
six Hex-head bolts (F1) and two 5/16" flange nuts (F2) for each
side as shown. Do not tighten completely.
F2
F2
P2
P1
P1
P3
3