Important; Pre-Installation Information - Bradley S19-270HD Instalación

S19-270HD, -270HW, -270JD, -270JW, -280D, -280W, -290D, -290W
Read this installation manual completely to ensure proper installation, then file it with the
Installation
owner or maintenance department. Compliance and conformity to drain requirements and
other local codes and ordinances is the responsibility of the installer.
Separate parts from packaging and make sure all parts are accounted for before discarding
Packing List
•
any packaging material. If any parts are missing, do not begin installation until you obtain
•
•
IS
T H
E •
S ID
the missing parts.
U P
Flush the water supply lines before beginning installation and after installation is complete.
Test the unit for leaks and adequate water flow. Main water supply to the eyewash should be
"ON" at all times. Provisions shall be made to prevent unauthorized shutoff.
The ANSI Z358.1 standard requires an uninterrupted supply of flushing fluid. Bradley
plumbed emergency fixtures require a minimum of 30 PSI (0.21 MPa) flowing pressure.
Flushing fluid should be tepid per ANSI Z358.1.
The inspection and testing results of this equipment should be recorded weekly to verify
proper operation. This equipment should be inspected annually to ensure compliance with
ANSI Z358.1.
Workers who may come in contact with potentially hazardous materials should be trained
regarding the placement and proper operation of emergency equipment per ANSI Z358.1.
P.O. BOX 309, MENOMONEE FALLS, WI 53052-0309 USA
TEL: 1-800-BRADLEY FAX: (262-251-5817) For questions regarding the operation or installation of this product, visit www.bradleycorp.
http://www.bradleycorp.com
114-051
com or call 1-800-BRADLEY.
Product warranties may also be found under "Product Information" on our web site at
www.bradleycorp.com.
Local codes may require the installation of a backflow prevention valve to complete proper installation. Compliance
with local codes is the responsibility of the installer. Valve must be tested annually to verify that it is functioning
properly. Backflow prevention valves are not included with the fixture and may be supplied by the contractor or
purchased from Bradley Corporation.
2

IMPORTANT

10/30/2012
Bradley • 215-1408 Rev. M; ECN 12-05-003C
Installation