Installing The Radio Control Receiver Board - Genius SPRINT 05 Instrucciones Para El Uso

5.2.7. Closing limit switch.
Terminals "FCC & COMF". Normally closed contact. It stops the gate closing movement. The status of this input
is signalled by LED "FCC".
Attention:
• Both limit-switches must be connected to ensure correct operation of the automated system.
• The COMF terminal must be used ONLY FOR connecting the common contact of the limit-switches.
The magnetic sensor supplied with the operator is designed for rapid connection to the control unit (Fig.2). To
use the sensor with this equipment, cut the connecting terminal from the sensor cable and connect the wires
on the terminal-board as indicated in paragraph 11. To connect the wires, follow the instructions in Fig.3.
5.3. TERMINAL BOARD CN3
5.3.1. Gearmotor
Terminals "APM - CHM - COM" (opens - closes - common). Connect the gearmotor power cables to these
terminals, connecting the capacitor between terminals APM and CHM.
5.3.2. Flashing lamp
Terminals "LAMP & N". Connect the flashing lamp to these terminals. Output of these terminals is 230V~.
Attention: The flashing is not commanded by the control unit but by the flashing lamp.
5.3.3. Power line
Terminals "N & F". Connect power supply line 230V~ 50Hz to these terminals.

6. INSTALLING THE RADIO CONTROL RECEIVER BOARD

The control unit is designed to house a 5-pin radio-receiver
module. Installation procedure: turn off power and fit the
module on connector CN4 (see Fig.1) on the control unit.
Attention: To avoid damaging the receiver and thus
irreparably compromising its operation, the receiver must
be installed, observing the fitting direction specified in
Fig.4.
Then, follows the radio-receiver instructions for memory-storing
the radio control.
Fig. 2
11
Fig. 3
Fig. 4