Technical Specifications; Control Unit - GI.BI.DI. F4 PLUS Instrucciones Para La Instalación

10
UK

1 - TECHNICAL SPECIFICATIONS

Control unit

Code
Type
Power supply
No. of motors
Motor power supply
Flashlight
Warning light
Electric lock
Accessory power supply
Radio receiver
Operating temperature
Degree of protection
2 - TECHNICAL SPECIFICATIONS/FUNCTIONS
• Red warning LEDs for the N.C. contacts (FCAM1-FCCM1-FCAM2-FCCM2-PHOTO-STOP).
• Green warning LEDs for the N.O. contacts (START-PED).
• Control of one 12VAC electric lock.
• Hammer stroke control.
• Run, pause and phase shift time adjustment.
• Fixed or intermittent flashlight control.
• Courtesy light control.
• Programming of automatic closing.
• Photocell active during closing (operation during opening can be selected with a DIP switch).
• Motor force adjustment with appropriate trimmer.
• Operating range: Automatic - Step-by-step with stop - Pedestrian.
• STOP input control with functioning as STOP (lock) or frame (obstacle freeing).
• Hydraulic retention for hydraulic motors (DIP1_10 ON).
• DIP switch to disable the LIMIT SWITCH and PHOTOCELL inputs if not used.
Thank you for choosing GIBIDI.
CAREFULLY READ THESE INSTRUCTIONS BEFORE PROCEEDING WITH INSTALLATION.
WARNINGS:
This product has been tested by GI.BI.DI. for full compliance with the requirements of the directives in force. GI.BI.DI. S.r.l. reserves
the right to change the technical data without prior notice in relation to product development.
DISPOSAL: GI.BI.DI. advises recycling the plastic components and to dispose of them at special authorised
centres for electronic components thus protecting the environment from polluting substances.
F4 PLUS
AS05950
Electronic control unit for automation of
a swing gate, sliding gate, overhead door or barrier
with one or two 230 VAC motor
230 VAC single-phase 50/60 Hz
1 or 2
230 VAC
230 VAC 40W max
24 VAC 3W max
12 VAC 15W max
24 VAC 8W max
Plug-in
-20°C +60°C
IP55
F4 PLUS