Hama SIRIUM1000ABT Instrucciones Breves página 9

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 26
Risk of electric shock
• Do not open the device or continue to operate it if
it becomes damaged.
• Do not use the product if the AC adapter, adapter
cable or power cable is damaged.
• Do not attempt to service or repair the product yourself.
Leave any and all service work to quali ed experts.
4. Before commissioning
Note
• You have the option of powering the product via mains
power or batteries. In order to use mains power, simply
connect the product to a power source. To use battery
power, the battery must be fully charged beforehand.
Note
• Use only original accessories (or accessories approved
by Hama) to avoid damage to the product.
• Only use the product at ambient temperatures between
-10°C and 50°C.
• Only store the product at ambient temperatures
between -20°C and 60°C.
5. Start-up and operation
Warning
• Only operate the product from a socket that has been
approved for the device. The socket must be installed
close to the product and must be easily accessible.
• Disconnect the product from the power supply using the
On/Off switch – if this is not available, unplug the power
cord from the socket.
• If using a multi-socket power strip, make sure that the
total power consumption of all connected devices does
not exceed the power strip's maximum throughput rating.
• If you will not be using the product for a prolonged
period, disconnect it from mains power.
5.1 Mains operation
Switching on
• Connect the mains lead on the loudspeaker to a properly
installed socket.
The loudspeaker switches on automatically.
Note – switching on for the rst time
• When rst switched on, the loudspeaker is in "Device
setup" mode and the status LEDs 2–6 pulse.
• If setup mode is not active, brie y press the [SETUP]
button (13) on the back of the device to activate WPS
mode ( ashes rapidly). Alternatively, press and hold
the [SETUP] button (13) for around 7 seconds to open
an AccessPoint ( ashes slowly).
Note - when switching on again
• At the next switch-on, all of the status LEDs 2-6 ash
orange until the connections made previously have
been restored. Depending on the internet signal
strength, this may take up to 20 seconds.
5.2 Battery operation
Warning – rechargeable battery
• Use only suitable chargers to charge the device's battery.
• Do not use defective chargers or USB ports and do not
attempt to repair them.
• Do not store, charge or use the device in extreme
temperatures.
• Charge regularly (at least quarterly) during periods
of prolonged storage.
• The product contains a rechargeable battery.
• Fully charge the product once before using it for the
rst time.
• Connect the mains lead on the loudspeaker to a properly
installed socket. The socket must be installed close to the
product and must be easily accessible.
• The loudspeaker switches on automatically.
• During the charging process, the current charge level
is indicated by the status LEDs.
3

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

0005488000054889

Tabla de contenido