Publicidad
Idiomas disponibles
Idiomas disponibles
These lights are intended for secondary warning only. They are not
intended for use as a primary warning system.
III.
INSTALLATION.
When installing equipment inside air bag equipped vehicles, the
installer MUST ensure that the equipment is installed ONLY in areas
recommended by the vehicle manufacturer.
Failure to observe this warning will reduce the effectiveness of the
air bag, damage the air bag, or potentially damage or dislodge the
equipment, causing serious injury or death to you or others.
For maximum coverage and effectiveness, the light assembly must be mount-
ed in a horizontal orientation.
Installation of the light assembly requires a flat mounting surface and clearance
behind the mounting surface for wire harness connection.
To install the light, proceed as follows:
Before drilling holes in ANY part of a vehicle, be sure that both sides of the
mounting surface are clear of parts that could be damaged; such as brake
lines, fuel lines, electrical wiring or other vital parts.
A. Recessed Mount. (See figure 1.)
1.
Using the template supplied in the mounting kit, scribe an outline
around the oval template.
2.
Remove the material inside the scribed oval's outline.
All drilled holes should be free of burrs and sharp edges. All wire routing
holes should be grommeted and/or sealed to avoid wire and/or vehicle damage.
3.
Insert the rubber grommet inside the cut oval.
4.
Complete the electrical connections.
5.
Snap in the 3600 Series light head into the grommet.
NOTE
-2-
Publicidad
