cam SMARTY Manual Del Usuario página 16

INSTRUCTIONS FOR SAFE USE
- Avoid leaving the D ring in the incorrect position (fig. 6C).
- Slightly turn the D ring clockwise (fig. 6D).
- Reach the locking position of the D ring (fig. 6E).
Strap "B": Do it as shown in the picture (fig. 7).
Fastening the harness (fig. 8). Seat unit locking harness "F":
After lowering the backrest (fig. 14), turn the booster seat upside down, making sure that the harness
"F" is in the correct position before inserting it into the right and left elements (fig. 9).
WARNING: the harness must pass between the frame and the seat unit as shown in fig. 9. Make pass
the harness into the right and left elements following the sequence from fig. 9A to fig. 9H.
POSITIONING AND FITTING THE BOOSTER SEAT
- Adjust the height of the booster seat and then make pass the locking harness "F" under the chair
and lock the buckle (fig. 10).
- Pull the end of the harness to tighten it (fig. 11).
- Make pass the seat unit backrest locking harness at the back of the chair and lock the buckle (fig.
12).
- Pull the end of the harness to tighten it (fig. 13). WARNING: before using the product, make sure the
booster seat is correctly fixed on the chair to prevent it from moving.
FOLDING THE PRODUCT
- Unlock all the safety harnesses.
- Push simultaneously the 2 buttons "A" placed under the armrests and lower the backrest at the
same time (fig. 14).
- Push simultaneously the 2 buttons "B" placed on the booster seat frame and push downwards the
frame at the same time (fig. 15).
- Once the product is completely folded, engage the seat unit locking harness "F" to prevent the
booster seat from opening again (fig. 16).
Transporting the product is very easy thanks to the practical carrying handle (fig. 17).
FOLDING THE TRAY (optional)
- Please refer to the image shown in fig. 18; insert part "N" (placed under the tray) into the relevant
housing "Q".
- Insert parts "R" into the relevant housings "U".
- Use the seat unit locking harness "F" to lock the tray to the product (fig. 19).
Transporting the product is very easy thanks to the practical carrying handle (fig. 20).
CARE AND MAINTENANCE
Prolonged exposure to the sun and inadequate washing can cause the colours to change. Limit
exposure if possible. Dry all metal parts should they get wet or damp. Never leave the product near
any source of strong heat (electrical heating or gas heating) to avoid fire danger. Clean the product
with a damp cloth or sponge and mild detergent. Do not use abrasive or bleach. The fabric cover is
hand washable in warm water (max 30 °C) with mild detergent (do not bleach). Do not use dryers, do
not dry clean, do not iron.
SPARE PARTS (fig. 21)
N° CODE
1 S332/1
2 S332/2
3 S332/3
4 S332/4
5 S332/5
6 S332/6
7 S332/7
8 S332/8
9 S333/9
16
DESCRITPTION
instruction manual
tray
backrest folding button
removable tray button
amrest screw
height adjuster button
anti slip feet (x4)
3 point harness
Fabric seat unit (optional)