Transport And Storage - Hilti TE 30-ATC/AVR Manual Del Usuario

• Clean the air vents carefully with a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
they can attack the plastic parts.
Maintenance
WARNING
Danger of electric shock! Improper repairs to electrical components may lead to serious injuries including
burns.
▶ Repairs to the electrical section of the tool or appliance may be carried out only by trained electrical
specialists.
• Check all visible parts and controls for signs of damage at regular intervals and make sure that they all
function correctly.
• Do not operate the product if signs of damage are found or if parts malfunction. Have it repaired
immediately by Hilti Service.
• After cleaning and maintenance, fit all guards or protective devices and check that they function correctly.
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by Hilti for use with the product can be found at your
local Hilti Store or online at: www.hilti.group.
7

Transport and storage

• Do not transport electric tools with accessory tools fitted.
• Always unplug the supply cord before storing an electric tool or appliance.
• Store tools and appliances in a dry place where they cannot be accessed by children or unauthorized
persons.
• Check electric tools or appliances for damage after long periods of transport or storage.
8 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
Trouble or fault
The power tool doesn't start.
The tool cuts out while run-
ning.
No hammering action.
*2069236*
Possible cause
Interruption in the electric supply.
Electronics
The tool is overloaded (application
limits exceeded).
Interruption in the electric supply.
The overheating prevention cut-out
has been activated.
ATC has been triggered.
The tool is too cold.
2069236
Action to be taken
▶ Plug in another electric tool or
appliance and check whether it
works.
▶ Reset the electronics by discon-
necting from the electric supply
for at least 1 minute.
▶ Select a tool that is suitable for
the intended purpose.
▶ Plug in another electric tool or
appliance and check whether it
works.
▶ Allow the tool to cool down.
Clean the air vents. Running
under no load is still possible.
▶ Release the control switch and
then press it again.
▶ Bring the tip of the drill bit
into contact with the working
surface, switch the rotary
hammer on and allow it to
run. If necessary, repeat the
procedure until the hammering
mechanism begins to operate.
English 19