Technical Data - Hilti TE 30-ATC/AVR Manual Del Usuario

If the motor is overloaded through application of excessive working pressure, the power tool's performance
drops noticeably or it may stall completely.
If the power tool stalls or slows significantly due to overloading, release the pressure applied to the tool and
then allow it to run under no load for approx. 30 seconds.
3.7 Items supplied
Rotary hammer, side handle, depth gauge, operating instructions.
You can find other system products approved for your product at your local Hilti Center or online at:
www.hilti.com
4

Technical data

4.1 Combihammer
For details of the rated voltage, frequency, current and/or input power, refer to the country-specific
type identification plate.
If the device is powered by a generator or transformer, the generator or transformer's power output must be
at least twice the rated input power shown on the rating plate of the device. The operating voltage of the
transformer or generator must always be within +5 % and -15 % of the rated voltage of the device.
Weight in accordance with EPTA procedure 01
Ø Hammer drill bits
Ø Drill bits for wood
Ø Drill bits for metal
4.2 Noise information and vibration values in accordance with EN 60745
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure. The data given represents the main applications of the power tool.
However, if the power tool is used for different applications, with different accessory tools, or is poorly
maintained, the data can vary. This can significantly increase exposure over the total working period. An
accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the
total working period. Identify additional safety measures to protect the operator from the effects of noise
and/or vibration, for example: Maintaining the power tool and accessory tools, keeping the hands warm,
organization of work patterns.
Noise emission values
Sound (power) level (L
Uncertainty for the sound power level (K
Emission sound pressure level (L
Uncertainty for the sound pressure level (K
Total vibration
Hammer drilling in concrete (a
Chiseling (a )
h, Cheq
Drilling in metal (a )
h, HD
Uncertainty (K)
16 English
)
WA
)
WA
)
pA
)
pA
)
h, HD
TE 30-ATC/AVR
4.0 kg
6 mm ... 28 mm
3 mm ... 25 mm
3 mm ... 13 mm
99 dB(A)
3 dB(A)
88 dB(A)
3 dB(A)
10 m/s²
9 m/s²
7 m/s²
1.5 m/s²
2069236
*2069236*