Front And Back View Of The Machine; Wand Selector Switch - Walter MINI SURFOX Manual De Usuario

5

Front and back view of the machine

Front and back view of the machine

Wand selector switch

ELECTROCHEMICAL CLEANING: Select this setting
when using the wand attached to the SURFOX unit. Select
LOW or HIGH depending on the amount of heat tint to re-
move and the type of material that is being cleaned. Brush
option and large insert can also be selected.
ELECTROCHEMICAL POLISHING: This mode is used for
cleaning, passivating and polishing the weld. The cleaning
and passivating process takes longer in the DC mode than
in the AC mode. DC mode is used to polish the weld bead
to match the surface of the finish.
8
Wand selector
switch
Power cable
connector for
cleaning wand
and optional
marking wand
Ground
connector
ELECTROCHEMICAL MARKING: Select this setting when
using a marking/etching wand which has been plugged into
the power cable connector. Select AC mode.
ELECTROCHEMICAL ETCHING: Select this setting when
using a marking/etching wand which has been plugged into
the power cable connector. Select DC mode.
Power switch