Storing Your Machine; Troubleshooting - Bissell PROHEAT PET TURBO 1799V Manual Del Usuario

Storing Your Machine

Once your cleaning is complete, make sure the the 2-in-1 tank and SmartMix® Tank is emptied and
rinsed out. Store in a closet or basement for the next use.

Troubleshooting

Below are some of the issues you may run into. If you don't see the issue you're experiencing
below, visit support.BISSELL.com.
Problem Possible Cause
Bladder may be empty.
Filter may be clogged.
Tanks may not be seated
properly.
Reduced spray Pump may have lost prime.
or no spray
Pump belt may be broken.
The 2-in-1 and SmartMix®
Tanks are empty.
Cleaning mode switch is not
fully on a mode.
DirtLifter®
Brush belt or pump belt is off
PowerBrush
or broken.
does not turn
ReadyTools™ Dial may be
on the wrong setting for the
cleaning job.
2-in-1 Tank lid is not properly
installed.
Reduced
suction or no 2-in-1 Tank is not properly
suction seated.
Poor tool position. (Handheld
attachments only.)
2-in-1 Tank has picked up
maximum dirty water.
WARNING
electrical outlet before performing maintenance or troubleshooting.
NOTICE
To reduce the risk of a leaking condition, do not store machine where freezing may occur. Damage to internal
components may result.
10 BISSELL.com
To reduce the risk of fire, electric shock, or injury, turn power OFF and disconnect plug from
Remedies
Refill bladder with hot tap water.
Clean out the flow indicator following steps on
page 8.
Turn power OFF (O); remove & reseat tanks.
Turn power OFF (O); after 1 minute turn ON and
press trigger.
Turn ON the machine and check to see that the
DirtLifter PowerBrush turns.
Refill tanks according to page 4.
Ensure the dial is in the correct position.
Turn the machine OFF (O) and unplug from
the outlet. To check if the brush belt or pump
belt has broken, you will need a flathead
screwdriver. Insert the blade end into the lower
slot of the Belt Access Door to release the lower
snap. If necessary, insert the blade end into the
upper slot to release the upper snap.
Examine the belt for breakage. If broken, visit
BISSELL.com for replacement part information.
Set ReadyTools™ Dial to the proper setting,
depending on how you are using your machine.
Reinstall lid following steps on page 4.
2-in-1 Tank must be firmly seated to function;
remove and reseat tank.
Adjust angle; apply more downward pressure.
Empty tank following steps on page 8.