Data Management - Hach HQ440d Manual Básico Del Usuario

Use a sample ID
The sample ID tag is used to associate measurements with a particular sample location. If assigned,
stored data will include the sample ID.
1. Push the key.
2. Select, create or delete a sample ID:
Option
Current ID
Create a New Sample ID Enter a name for a new sample ID.
Delete Sample ID
Use an operator ID
The operator ID tag associates measurements with an individual operator. All stored data will include
the operator ID.
1. Push the key.
2. Select, create or delete an operator ID:
Option
Current ID
Create a New Operator ID Enter a name for a new operator ID (maximum 10 names can be entered).
Delete Operator ID

Data management

About stored data
The following types of data are stored in the data log:
• Sample measurements: stored automatically each time a sample is measured in the Press to
Read or Interval Mode. When the continuous measurement mode is used, data is stored only
when Store is selected.
• Calibrations: stored only when Store is selected at the end of a calibration. Calibration data is also
stored in the IntelliCAL (R) probe.
• Check standard measurements: stored automatically each time a check standard is measured (in
the Press to Read or Interval Mode).
When the data log becomes full (500 data points), the oldest data point is deleted when a new data
point is added. The entire data log can be deleted to remove data that has already been sent to a
printer or PC ( key > Delete Data Log). To prevent deletion of the data log by a user, use the
Security Options menu.
12 English
Description
Select an ID from a list. The current ID will be associated with sample data until a
different ID is selected.
Delete an existing sample ID.
Description
Select an ID from a list. The current ID will be associated with sample data until
a different ID is selected.
Delete an existing operator ID.