veito BLADE S Manual De Instalación E Instrucciones página 10

OPERATION
Press the button to turn on the heater at high level or
change the heat setting.
Press the button to turn on the heater at low level or
change the heat setting.
Press the button to set the required room temperature.
The heater will adjust the level when the temperature set
has been reached.
Press the button repeatedly to cycle through the sleep
time options:
1h – 2h – 3h – 4h – 5h – 6h – 7h – 8h – 9h – OFF
Once the sleep time is expired, the unit will be switched
off.
During operation, press the button once to check the
remaining sleep time.
Press the button to turn the heater off.
You can also use the button on the unit to operate the heater.
REPLACING REMOTE CONTROL BATTERIES
Replace all two batteries when the remote control stops operating or its range
seems reduced.
Slide the battery compartment cover off.
Symbols inside the compartment show how to match the - and + symbols on
the batteries.
Insert the two AAA batteries, making sure to match the - and + symbols.
Slide the cover back on until it clicks into place.
Note: Do not allow water or liquid to get into the remote control.
10
EN