Cleaning And Maintenance; Technical Data - Adler europe AD 7922 Manual De Uso

H(2seconds) -> M(6seconds) -> L(4seconds) will be repeated again and again.
When choose the high fan speed: Air flow cycle: H(4seconds) -> M(6seconds) -> H(8seconds) -> M(4seconds) -> H(6seconds) ->
L(4seconds) -> H(6seconds) -> M(4seconds) -> H(8seconds) -> M(10seconds) -> H(8seconds) -> M(6seconds) -> H(4seconds) ->
M(2second) -> H(6seconds) -> M(10seconds) will be repeated again and again.
- "SLEEP" mode: based on the "NATURAL" speed sequence, the unit automatically reduces the fan speed approximately every 30
minutes.
When you press high fan speed: the unit will slow down to medium speed after 30 minutes, then slow down after another 30 minutes to
always blow at low speed.
If you press medium fan speed, the unit will reduce the medium fan speed to low speed after 30 minutes to always blow at low speed.
When pressing low speed: the device will blow at low fan speed all the time.
9. All buttons on remote control (10) have got same functions as buttons on control panel (1).
Do not place any objects between the device and the remote control to ensure proper communication between the remote control and
the device. To start remote control (10) operation pull out the installing film. To replace the push the release tab and take battery out the
battery carriage. Replace with a battery of the same type, refit the battery in reverse order.

CLEANING AND MAINTENANCE

Always unplug the device before you start to clean or water empty the device.
1. Clean with soft, dry cloth. Do not use chemical solvents because they can cause permanent damage or deformation of the device.
2. If the device is not used for three or more months, take the batteries out of the remote control.
3. After long time operation, the air inlet cover (7) and inner filter (6) will be clogged with the dust, which will greatly affect the device's
performance of cooling. If long time no changing water, there may be mold and mildew. We suggest to clean the air inlet cover (7) and
inner filter (6) once every two weeks. The filter clean procedure is as below:
a) Unplug the device, remove two screws of the back housing by screwdriver and then take the cover (7) and filter (6) out.
b) Wipe clean or clean using a vacuum cleaner. Use the duster it gently dust off the inner filter (6).
c) Put the inner filter (6) and inlet cover (7) back in place and tighten the screws.
4. Drain the water before seasonal storage by removing the water tank (chapter Using the Device - point 2). Use mild soap and water to
clean the water tank. Then dry the device and water tank completely to avoid the moisture damage.
5. Drain the water from the plastic containers (5) before storage.
6. Make sure the water tank (8), the inner filter (6) and inlet cover (7) are replaced in correct position before switching on again.

TECHNICAL DATA:

Power supply 220-240V ~50 Hz
Power: 65 W
Power Max: 350 W
Tank capacity: 6 liters
Water Consumption: 0,5 liter / hou
Battery: CR2025 (3V)
To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding waste
bins. Used appliance should be delivered to the dedicated collecting points due to hazarsous components, which may
effect the environment. Do not dispose this appliance in the common waste bin.
SICHERHEITSBEDINGUNGEN. WICHTIGE ANWEISUNGEN ZUR VERWENDUNG DER
SICHERHEIT
BITTE LESEN SIE SORGFÄLTIG DURCH UND BEWAHREN SIE DIE ZUKÜNFTIGE
VERWEISE AUF
Die Garantiebedingungen sind unterschiedlich, wenn das Gerät für kommerzielle Zwecke
verwendet wird.
1. Bevor Sie das Produkt verwenden, lesen Sie es bitte sorgfältig durch und befolgen Sie
immer die folgenden Anweisungen. Der Hersteller haftet nicht für Schäden, die durch
Missbrauch entstehen.
2. Das Produkt darf nur in Innenräumen verwendet werden. Verwenden Sie das Produkt
nicht für Zwecke, die nicht mit seiner Anwendung kompatibel sind.
3. Die anwendbare Spannung beträgt 220-240 V, ~ 50 Hz. Aus Sicherheitsgründen ist es
nicht angebracht, mehrere Geräte an eine Steckdose anzuschließen.
4. Seien Sie bitte vorsichtig, wenn Sie Kinder benutzen. Lassen Sie die Kinder nicht mit
dem Produkt spielen. Lassen Sie Kinder oder Personen, die das Gerät nicht kennen, es
Device is made in class I of insulation and has to be connected
only to power outlet with ground circuit.
Device is compliant with EU directives:
Low voltage directive (LVD)
Electromagnetic compatibility (EMC)
Device marked CE mark on rating label
DEUTSCH
5