Style selections 8865GYMV Manual De Instrucciones página 6

ASSEMBLY INSTRUCTIONS
7. Place the assembly in the desired location and
mark the mounting points on wall through the
holes in the back tubes of the unit.
NOTE: Wall anchors (GG) should be oriented
with the flat side horizontal.
Hammer the wall anchors (GG) into wall, unless
mounting screws (EE) will go directly into a stud.
Insert the mounting screws (EE) through the
holes in the back tubes and the spacers (FF)
of the unit.
Place unit against the wall, lining up the mounting
screws (EE) to the holes in wall and complete
the mounting by tightening mounting screws (EE)
into the studs or wall anchors (GG), as shown.
Hardware Used
Mounting Screw
EE
FF
Spacer
GG
Wall Anchor
8. Attach the last straight tube (C) to the bottom
side panels (D) with screws (BB), as shown.
Hardware Used
BB
Screw
IS08865-I
7
x 2
x 2
x 2
8
x 2
6
GG
FF
EE
C
BB