Dimplex DF2550-EU El Manual Del Propietario página 12

Operation
Figure 5
On button
Off button
Plastic
strip
Battery
cover
replaced, you may need to
initialize the remote.
From a powered off state:
①
Ensure power is supplied to
the fireplace through the main
service panel.
②
Locate manual controls and
activate main on/off switch
(Figure 4-A).
③
Press and hold the " I " button
(Figure 4-B) until all indicator
lights flash.
④
Press the ON button on the
remote control. the indicator
lights will flash rapidly then turn
off.
12
Remote Control Usage
the remote control operates the
fireplace levels sequentially (from
off): flames only; to flames and
low heat; to flames and high heat.
the level is increased every time
the ON button is pressed on the
remote control transmitter and the
fireplace can be turned off at any
point by pressing the oFF button.
Battery Replacement (Figure 5)
to replace the battery:
①
slide battery cover open on
the hand held transmitter.
②
Install one (1) 12 Volt (A23)
battery in the battery holder.
③
Close the battery cover.
www.dimplex.com