Installation Steps - LUND Interceptor Instrucciones De Instalación

Installation Steps

3
Align holes in hood shield with holes in hood in order to
center part in place. Note the location where the brackets
will align with hood edge and mark with a grease pencil.
4
Position hood shield back in place on hood. Ensure that the holes
in hood shield are properly aligned with the holes in the hood and
that the bracket aligns with the protective film.
6
Insert (4) fasteners through the hood shield and into
the hood and securely tighten.
8
DO NOT OVER TIGHTEN
NOTE: Actual application may vary slightly from illustrations.
Install (2) brackets on outboard hood shield flanges using machine screws and black washers.
Remove hood shield.
fastener
hood shield
X4
hood
Center a piece of protective film over each grease pencil
mark, and wrap around the hood edge.
5
Slide brackets over hood edge, ensuring that they are centered
on the protective film previously installed in Step 6.
7
Close hood and Install (4) bump ons at pre-cleaned
9
Page 2 of 3
washer
hood shield
bracket
bracket
protective film
hood
locations on the painted hood surface.
screw
X2
X2
X2