Product Safety Information; Product Specifications - Ingersoll Rand 231TL-2 Serie Manual De Instrucciones

Product Safety Information

Intended Use:
This Torque Limited Air Impact Wrench is designed to remove threaded fasteners and to partially
tighten and seat a threaded fastener in preparation for manually tightening to the
recommended torque using a calibrated torque wrench.
Do not use this tool for final tightening of threaded fasteners. The reduced torque in the
forward direction is only intended to seat the fastener in preparation for final torquing.
Always manually torque the fasteners to the recommended torque after using this tool.
For additional information refer to Product Safety Information Manual Form 45528239.
Manuals can be downloaded from ingersollrandproducts.com
Power Management System
The power management system on this model can not be adjusted by the user. It is locked at the
factory to always provide full power in reverse and reduced power in forward.

Product Specifications

Model(s) Style
231TL-2 Pistol
Model(s)
231TL-2
† K = 3dB measurement uncertainty
pA
‡ K = 3dB measurement uncertainty
wA
Sound and vibration values were measured in compliance with internationally recognized
test standards. The exposure to the user in a specific tool application may vary from these
results. Therefore, on site measurements should be used to determine the hazard level in
that specific application.
80181852_ed4
DANGER
Drive
Type Size
Square
1/2"
2" extended
Sound Level dB (A)
(ISO15744)
† Pressure (L )
p
102.8
WARNING
Recommended
Torque Range
Impacts
per min.
Forward
ft-lb (Nm)
1,150 35-55 (47-75)
‡ Power (L )
w
113.8
* K = Vibration measurement uncertanity
EN
Reverse
ft-lb (Nm)
350 (475)
Vibrations m/s²
(ISO28927)
Level * K
12.4 4.3
EN-1