Philips Avent SCF356/00 Manual Del Usuario página 12

ENGLISH
14
Re-using the baby bottle warmer right away for
another bottle
If you want to heat up another bottle right away, let the baby
bottle warmer cool down for a few minutes. To speed up this
process, fill the baby bottle warmer with fresh cold water.
When you switch on the baby bottle warmer, the progress
indicator starts flashing from bottom to top to indicate that
the appliance is heating up again.
Note: If the progress indicator is on but does not flash, the
baby bottle warmer is still too warm to heat up another
bottle. Please switch off the baby bottle warmer, let it cool
down for a few minutes and make sure you fill it with fresh
cold water.
Using the baby bottle warmer to warm baby food
1
Put the mains plug in the wall socket (Fig. 3).
2
Place a baby food container or jar centrally in the baby
bottle warmer (Fig. 15).
Note: You can leave off the lid of the food container or jar,
so you can stir the baby food during heating.
3 Fill the baby bottle warmer with the same amount of
drinking water as the amount of baby food you want to
warm up (for example, to warm up 125ml/4oz of baby
food, you need to use 125ml/4oz of drinking water). If
you want to warm up a large amount of baby food, the
maximum water level is approximately 1cm/0.4 inches
under the rim of the baby bottle warmer (which
corresponds to adding 160ml/4.5oz of drinking water).
An accurate water level ensures correct warming
performance. (Fig. 16)
4
Select the baby food warming setting (Fig. 17).
5
Press the on/off button to switch on the appliance. The
light in the progress indicator shows that the baby bottle
warmer is on (Fig. 18).