Brushing Instructions - Philips Sonicare FlexCare Platinum Connected HX9191/07 Manual De Instrucciones

2 Download the Philips Sonicare app from the App Store or Google
Play.
3 Confirm Bluetooth is switched on on your mobile device before
you open the app. Check the settings on your mobile device to
turn on Bluetooth.
4 To connect the toothbrush to the app, turn on the toothbrush by
pressing either the power on/off button or the brushing mode
button. Make sure the toothbrush is not on the charger when you
turn it on.
5 Open the Sonicare app.
6 Follow the Sonicare app instructions displayed on your mobile
device. The app automatically connects with the toothbrush. If the
toothbrush does not connect, follow the troubleshooting steps
provided in the app.
Note: For optimal data capture keep your mobile device close whilst
brushing.

Brushing instructions

1 Wet the bristles and apply a small amount of toothpaste.
2 Place the toothbrush bristles against the teeth at a slight angle (45
degrees), pressing firmly to make the bristles reach the gumline or
slightly beneath the gumline (Fig. 6).
Note: Keep the center of the brush in contact with the teeth at all
times.
3 Press the power on/off button to turn on the Philips Sonicare.
4 Apply light pressure to maximize Philips Sonicare's effectiveness
and let the Philips Sonicare toothbrush do the brushing for you. Do
not scrub.
5 Gently move the brush head slowly across the teeth in a small
back and forth motion so the longer bristles reach between your
teeth. Continue this motion throughout the brushing cycle.
6 To clean the inside surfaces of the front teeth, tilt the brush handle
semi-upright and make several vertical overlapping brushing
strokes on each tooth (Fig. 7).
13
English