Niko 16-651 Manual Del Usuario página 22

16-651
3.2 Programming the video image
➥ ➊
Entering the system's programming mode on the interface
push for ±1s.
➥ ➋
Programming address of bell push button
press briefly
➥ ➌
Programming the last address that was put on the bus in the internal unit(s)
5 x beep => last address programmed
Note:
no beep => address had already been programmed
➥ ➍
Exiting the system's programming mode
push for ±1s.
4. RESETTING
4.1. Entering the system's resetting mode (on the 16-651)
keep pushing (±6s.) until reset LED blinks
4.2. Deleting one address (of bell push button or 16-657)
press briefly (address deleted in all internal units)
22
program LED blinks
Programming address of camera interface 16-657-01
or
LED blinks (system in programming mode)
beep (address on the bus)
or
1. LED blinks (system in programming mode)
2. press briefly
3. LED blinks quickly (last address has been programmed)
(= ditto for 16-667, 16-656-01,...)
LED stops blinking
or
1. RED LED blinks (system in reset mode)
2. press briefly
3. LED blinks quickly (address deleted in all internal units)
press briefly
LED blinks quickly (address on the bus)
EN