16-651
4.3. Deleting an internal unit
5 x beep => internal unit deleted
Note:
no beep => internal unit had already been deleted (empty)
4.4. Exiting the system's reset mode
keep pushing (±6s.) until reset LED goes out
4.5. Resetting the system completely
- Press the 'Program' and 'Reset' key simultaneously for 6s.
- Both LEDs light.
- After pressing for 6s. the LEDs blink and you can let go of the keys.
- The video system has been deleted completely.
5. OPERATION AND USE
- If the audio and video part are programmed correctly and the bell is rung, the display of the correct internal unit(s) light(s) and the correct telephone(s) ring(s). The display is activated for as long as the call lasts.
- Pick up the receiver to talk to your visitor. You can control the electric locks during the conversation. Press key 1 or 2 (depending on the lock you wish to control) (see table). Press ✱ to end the conversation.
6. TECHNICAL DATA
Dimensions: ..................................................................L483 x W213 x H55mm
Weight:.........................................................................2941g
Operating temperature: .................................................5 to 55°C
Enclosure: ....................................................................metal
Connector to external unit: .............................................RJ45 (or alternatively screw connector)
Connector to splitter/switcher: .......................................RJ45
Dead N.O.-contacts: ......................................................2 contacts; 10A
Power supply: ...............................................................supplied via used cable (e.g. UTP cat. 5E)
Audio and video connection: ..........................................via twisted pair
7. LEGAL WARNINGS
- The installation has to be carried out by a qualified person and in compliance with the statutory regulations.
- This user manual has to be handed over to the user. It has to be included in the electrical installation file and has to be passed on to any new owners. Additional copies are available on the Niko website or via the support
service.
- During installation, the following has to be taken into account (not limited to list below):
- The statutory laws, standards and regulations;
- The state of the art technique at the moment of installation;
- This user manual, which must be read within the scope of each specific installation, only states general regulations;
- The rules of proper workmanship
- In case of questions, you can consult Niko's support service or contact a registered control organisation.
Support Belgium:
Support UK:
+32 3 778 90 80
+44 1525877707
website : http://www.niko.be
http://www.nikouk.com
e-mail: support@niko.be
sales@nikouk.com
In case of a defect, you can return your product to a registered Niko wholesaler, together with a clear description of your complaint (Conditions of use, stated defect...).
8. GUARANTEE PROVISIONS
- Period of guarantee: 2 years from date of delivery. The delivery date is the invoice date of purchase of the product by the consumer. If there is no invoice, the date of production applies.
- The consumer is obliged to inform Niko in writing about the defect, within two months after stating the defect.
- In case of a failure to conform, the consumer has the right to a repair or replacement (decided by Niko) free of charge.
- Niko cannot be held liable for a defect or damage as a result of an incorrect installation, improper or careless use or wrong usage or transformation of the goods.
- The compulsory regulations of the national legislation concerning the sales of consumer goods and the protection of the consumers in the countries where Niko sells, directly or via sister or daughter companies, chain stores,
distributors, agents or permanent sales representatives, take priority over the rules and regulations mentioned above.
EN
or
1. LED blinks (system in reset mode)
2. press briefly
3. LED blinks quickly (internal unit deleted)
(= ditto for 16-667, 16-656-01,...)
23