EWS 115..125 ES - Buch Seite 19 Donnerstag, 20. Juli 2006 11:44 11
Maintenance and Cleaning
Before any work on the machine itself, pull the
mains plug.
For safe and proper working, always keep the
machine and its ventilation slots clean.
In extreme working conditions, conductive
dust can accumulate in the interior of the
machine when working with metal. The pro-
tective insulation of the machine can be
degraded. The use of a stationary extraction
system is recommended in such cases as well
as frequently blowing out the ventilation slots
and installing a residual current device (RCD).
If the machine should fail despite the care taken in
manufacturing and testing, repair should be carried
out by a Würth Master-Service agent.
For all correspondence and spare parts orders,
always include the article number on the type plate
of the machine.
For the current spare parts list of this machine, log
into the Internet under "http://www.wuerth.com/
partsmanager" or ask for a copy at your nearest
Würth branch office.
Disposal
Power tools, accessories and packaging should be
disposed of for recycling in an environmentally
friendly manner.
Only for EU countries
Do not dispose of power tools into
household waste!
According to the European Guide
Lines 2002/96/EC for waste electric
and electronic equipment and its implementation
into national law, power tools that are no longer
usable must be collected separately and recycled in
an environmentally friendly manner.
Würth will gladly take back your defective Würth
power tool free of charge.
For this Würth tool, we provide a warranty in
accordance with statutory /country-specific regula-
tions from the date of purchase (proof of purchase
by invoice or delivery note). Damage that has
occurred will be corrected by replacement or repair.
Damage caused by normal wear, overloading or
improper handling is excluded from the warranty.
Claims can be recognised only when the tool is pre-
sented undisassembled to a Würth branch office or
a Würth field service employee
Noise/Vibration Information
Measured
EN 60 745.
Typically, the A-weighted noise levels of the tool are:
Sound pressure level: 90 dB (A); Sound power level:
101 dB (A). Uncertainty K = 3 dB.
Wear ear protection!
Total vibration values (vector sum in the three axes)
determined according to EN 60 745:
– Surface grinding:
vibration emission value a
uncertainty K = 1.5 m/s
– Vibration emission value a
uncertainty K = 1.5 m/s
– Sanding with Sandpaper:
vibration emission value a
uncertainty K = 1.5 m/s
Declaration of Conformity
We declare under our sole responsibility that this
product is in conformity with the following standards
or
standardization
according to the provisions of the regulations
89/336/EEC, 98/37/EC.
06
Adolf Würth GmbH & Co. KG
P. Zürn
Subject to change without notice
Warranty
values
determined
according
= 6.5 m/s
h,AG
2
(EWS 115)
= 8.0 m/s
h,AG
2
(EWS 125-S/ES)
= 3.5 m/s
h,DS
2
documents:
R. Bauer
to
2
,
2
,
2
,
EN 60 745
19