Tripp-Lite TLNETCARD El Manual Del Propietario página 5

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation
1
Access the TLNETCARD Accessory Slot: Use a screwdriver to
remove the accessory slot cover from the UPS. Retain the screws for
securing the appropriate faceplate for your UPS.
2
Insert TLNETCARD into Accessory Slot: Ensure that the two DIP
switches on the TLNETCARD are in the OFF position (Normal Mode).
While the UPS is turned on, align the TLNETCARD with the guides in
the accessory slot and push the card into the slot until the ports are
nearly even with the rear side of the UPS.
3
Attach Faceplate: Align and attach the faceplate that matches your
UPS system, using the screws from the accessory slot cover.
16-01-412-933525.indb 5
5
1/28/2016 3:02:05 PM

Publicidad

Tabla de contenido
loading

Tabla de contenido