Franklin Electric Little Giant FP-CC-V Manual Del Usuario

Franklin Electric Co., Inc.
Oklahoma City, OK 73127
www.lg-outdoor.com
customerservice@lgpc.com
INTRODUCTION
EN
This instruction sheet provides you with the information required
to safely own and operate your product. Retain these instructions
for future reference.
The product you have purchased is of the highest quality
workmanship and material, and has been engineered to give you
long and reliable service. This product has been carefully tested,
inspected, and packaged to ensure safe delivery and operation.
Please examine your item(s) carefully to ensure that no damage
occurred during shipment. If damage has occurred, please
contact the place of purchase. They will assist you in replacement
or repair, if required.
READ THESE INSTRUCTIONS
ATTEMPTING TO INSTALL,
YOUR PRODUCT. KNOW THE PRODUCT'S APPLICATION,
LIMITATIONS, AND POTENTIAL
YOURSELF AND OTHERS BY OBSERVING ALL SAFETY
INFORMATION. FAILURE
INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/
OR PROPERTY DAMAGE!
SAFETY GUIDELINES
1. Make certain that the unit is disconnected from the power
source before attempting to service or remove any component.
2. Do not use to pump flammable or explosive fluids such as
gasoline, fuel oil, kerosene, etc. Do not use in explosive
atmospheres. Pump should only be used with liquids
compatible with pump component materials.
3. Do not handle pump with wet hands or when standing on wet
or damp surface or in water.
4. This pump is supplied with a grounding conductor and/or
grounding type attachment plus. To reduce the risk of electric
shock be certain that it is connected to a properly grounded
grounding type receptacle.
5. The National Electric Code (in the USA) and similar codes
in other countries require a Ground Fault Circuit Interrupter
(GFCI) to be installed in the branch circuit supplying fountain
equipment rated above 15 volts. Franklin Electric recommends
that each pump be used with a GFCI.
6. Do not allow children or infants to play near the fountain due
to drowning hazard.
ELECTRICAL CONNECTIONS
1. Check the pump label for proper voltage required. Do not
connect to voltage other than that shown.
2. If the pump is supplied with a 3-prong electrical plug, the third
prong is to ground the pump to prevent possible electrical
shock hazard. DO NOT REMOVE the third prong from the
plug. Do not use an extension cord.
COTTAGE CAULDRON
CHAUDRON ARTISANAL
CALDERO DE CABAñA
FP-CC-V
CAREFULLY BEFORE
OPERATE, OR SERVICE
HAZARDS. PROTECT
TO COMPLY WITH THESE
3. There is an adjustment on the pump to regulate the flow
of water.
ASSEMBLY AND OPERATION
1. Remove the fountain assembly and all packaging from the box
and place them on a smooth, flat surface. NOTE: The suction
cups and adapter are not required for this application and are
not included.
2. Remove the ornamental pump from the cauldron.
3. Locate flexible tubing on the ornamental pump and connect
the tubing to the electric pump.
4. Feed the electrical plug through the center hole at the top of
the cauldron and then through the overfill hole at the base of
the cauldron, allowing the electrical pump to go through the
center hole but sit at the bottom of the cauldron.
5. Fill the cauldron with water until the electric pump is fully
submerged.
6. Align the ornamental pump on the cauldron and loosen the
mounting bolts so that the ornamental pump can stand flat on
the top surface.
7. Tighten the mounting bolts into the mounting holes using a
wrench. DO NOT OVER-TIGHTEN.
8. Connect the electric pump to power and allow approximately
20 seconds for water to begin flowing from the ornamental
pump.
9. Use the adjustment on the pump to regulate the flow of water.
MAINTENANCE
1. Do not allow the pump to run without water or to freeze.
2. Clean fountain only with water and, if desired, use only
a tablespoon of chlorine to prevent algae. DO NOT USE
BLEACH. It may tarnish the applied finish.
TROUBLESHOOTING
PROBLEM
Pump is not working.
Pump is working but
water is not flowing.
FRANÇAIS
FR
Cette feuille d'instructions vous fournit les informations nécessaires
pour entretenir et faire fonctionner votre produit. Conserver ces
directives afin de pouvoir les consulter plus tard.
Le produit que vous avez acheté a été soigneusement fabriqué
avec des matériaux de la plus haute qualité et a été conçu pour
durer longtemps et offrir un service fiable. Les produits sont
soigneusement testés, inspectés et emballés afin d'en assurer la
sécurité de fonctionnement et une livraison en bonne condition.
Vérifier attentivement le produit afin de vous assurer qu'il n'a
pas été endommagé pendant le transport. S'il est endommagé,
veuillez contacter l'entreprise qui vous l'a vendu. Si une réparation
ou un remplacement est requis, elle vous prêtera assistance.
LIRE ATTENTIVE MENT CES DIRECTIVES AVANT DE
PROCÉDER À L'INSTALLATION , À L'UTILISATION OU À
L'ENTRETIEN DU PRODUIT . SE FAMILIARISER AVEC LES
APPLICATIONS , LES LIMITES ET LES RIS QUES POTENTIELS
DU PRODUIT . ASSURER SA PROPRE PROTECTION ET CELLE
CORRECTIVE ACTION
Check power outlet. Refer to manu-
facturer's instructions.
Check for kinks in the tube. Make
sure pump is submerged. Make sure
pump is free of debris and the impeller
turns freely by cleaning the inside of
the pump.