Delay Start - Avanti CTW14X0W-IS Manual De Instrucciones

PRESS DOWN START/PAUSE BUTTON ONCE AND THE MACHINE WILL BEGIN OPERATION.
Please press this button to stop the normal operation, if it continues to work, press it again.
Water level can be reset during the normal operation after pressing the PAUSE button. If the higher
water level is selected, the machine will operate after refilling the water level selected.
FULLY AUTOMATIC – FUZZY LOGIC PROGRAM.
Your machine incorporates the fuzzy logic program, which will automatically select the load size and
select the cotton wash program.
Press the Power button.
Press the Start / Pause button, the tub will start to spin back and forth the weigh the clothes in the tub
and then will be operation.
The machine will work in the Cotton wash program as a default.
In the event the clothing being washed becomes unbalanced, the safety switch will be activated, and
the washing machine will automatically refill with water to adjust the imbalance.
Note:
· Clothes easily discolored should be washed separately so as to prevent inter-dyeing.
·
If you want to change a selected program, press the POWER button first to turn the unit off, then
press the POWER button again to turn the unit back on, then press the Program button to select
the new cycle before pushing START/PAUSE button.
·
When the Rinse and Spin functions are ON, do not use detergent.
·
If you want to drain the water during washing, press the POWER button first to turn the unit off,
then press the POWER button again to turn the unit back on, then select the SPIN function. Press
START/PAUSE button again to restart.
ADDING / REMOVING CLOTHING AFTER THE CYCLE HAS STARTED
Your washing machine is equipped with a safety system that will stop the machine when the
lid is opened during a wash cycle.
To add or remove clothing to/from a wash cycle follow the steps below:
·
Open the lid, the machine will stop (E2 will flash in the display and a beep will sound).
·
Add or remove the clothing as needed.
·
Close the lid, the washing machine will continue the previous wash cycle.

DELAY START

Your machine can be programmed to start at a later time, to activate the delay start program (2 – 24
hours) follow these steps:
Press the Power button.
Select the desired wash program by pressing the program button until the wash program number is
shown in the display window.
Press the load size button to select the size of laundry load to be washed.
Hold the program button for approximately 3 seconds, "2" will be shown in the window, press the
program button to select the desired start time.
Press the START / PAUSE button to activate.
The preset start time and ( • ) will flash in the display window. Once the delay time has elapsed, the
washer will begin the pre-programmed wash cycle.
19