ROTOR S3X Guia De Instalacion

#1. STEERER TUBE PREPARATION.
OPEN
ANTICLOCKWISE
#2. STEERER TUBE INSTALLATION
ALLEN 4mm
6 Nm
CLOSE
CLOCKWISE
#4. FACE PLATE PREPARATION.
Apply friction paste to face plate and stem contact surfaces.
SAFETY WARNING
This owner's manual contains important and useful information regarding the proper installation, operation, care, and maintenance of your ROTOR product. Carefully read, follow and understand the
instructions given in this manual. You should keep this manual in a safe place for future reference.
Do not perform any modifications or adjustments that are not outlined in this manual. If you have any doubt whatsoever regarding your ability to service or repair this product, please take your bicycle to a
qualified repair shop for the assistance of a professional mechanic.
Incorrect installation or service may impair performance, and could result in a dangerous situation leading to injury or death.
Please have this product regularly inspected by a qualified mechanic for any signs of wear. Components that have experienced excessive wear, cracks, deformations or impacts need immediate replacement.
Failure to perform maintenance could drastically reduce the service life of your ROTOR S3X stem and reduce its performance.
If you have any questions, please contact a professional bike mechanic or your nearest ROTOR dealer for additional information, or contact info@rotorbike.com.
Caution!: If any instructions within this User Manual are contrary to the instructions given by the manufacturer of your handlebar, fork, frame etc, contact their service department to explain your plan and
request their approval.
MAINTENANCE
Inspect your ROTOR S3X stem for cracks and serious scratches, looseness, damage or weakness before each ride, and after every fall or crash. If any of the preceding conditions are present, do not use your
ROTOR S3X stem until it has been repaired or replaced.
WARNING: Continuing to use damaged parts may lead to loss of control of the bicycle and cause injury or death.
It is the product users' responsibility to examine the product on a regular basis to determine the need for service or replacement. Cyclist should inspect their bicycle and its components on a regular basis in
order to detect damage that may have occurred from normal use and abuse. Check all parts for damage and wear before every use.
ROTOR WARRANTY POLICY:
The ROTOR S3X STEM and its components are guaranteed for 2 YEARS against any manufacturer defects or defective materials. In the event of a warranty defect, ROTOR´s sole obligation under
this warranty is to repair or replace, at its option, the defective part or product at no charge. Moreover, in some countries, Rotor is obliged to ensure any legal warranty defined by law for the customer's
protection.
- Elements subject to wear and breakdowns that the manufacturer is not responsible for, are not covered by this warranty.
- Failures or breakdowns caused by improper use, poor assembly or inadequate maintenance as declared in the instructions or the user manual are not covered by this warranty.
- Always keep your receipt or invoice, this warranty does not cover products whose serial number or identification has been erased, damaged or modified.
These and other instructions for all Rotor Bike Components products are available for download at:
ROTOR COMPONENTES TECNOLÓGICOS SL - info@rotorbike.com
Pol. Ind. Conmar, C/Miño, 16-18. 28864 Ajalvir, Madrid, Spain. Tel. +34 91 884 3846. Fax: +34 91 884 3865
ROTOR S3X STEM. INSTALLATION GUIDE.
ALLEN 4mm
1,5 - 2 TURNS
.
MAX.
4mm
MINIMUM
INSERTION
DEPTH 30mm
www.rotorbike.com
#3. REMOVE THE FACE PLATE.
ALLEN 4mm
#5. HANDLEBAR INSTALLATION.
TM
Revised 10/2010
DO NOT
REMOVE
THE BOLT
Tighten each bolt alternately.
PARALLEL GAP
~2mm
5 Nm
ALLEN 4mm
TM