Descargar Imprimir esta página
GE SmartWater GXIT Instrucciones Para La Instalación
GE SmartWater GXIT Instrucciones Para La Instalación

GE SmartWater GXIT Instrucciones Para La Instalación

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Your new GE icemaker water filter comes complete with all the necessary hardware for installation.
Each filter gives you up to six months of great-tasting water.
Filter should be changed after six months of use.
REQUIRED TOOLS FOR INSTALLATION
• a tube cutter
• 7/16", 1/2" and 9/16" wrenches
• a knife
• a bucket or pan
CAUTION: Using pliers or vise grips WILL
damage the fittings.
WARNING
Do not use where water is microbiologically
unsafe or with water of unknown quality
without adequate disinfection before or
after the filter.
Small parts remaining after the installation
could be a choke hazard. Discard safely.
Model
GXIT
If slow water or hollow ice occurs, replace filter.
• Protect from freezing. Drain filter when room temperature drops below 32°F. (0°C.).
• Use the in-line water filtering system on a potable, safe-to-drink, home COLD water supply only. The filter
will not make unsafe water safe to drink. Do NOT use on HOT water (100°F. max.).
• Do not install on line pressure above 125 psi (862 kPa), or below 25 psi (172 kPa).
• All of the refrigerator installation requirements must be met when installing the filter.
• Do not use wicking or pipe dope sealer for fitting connections into head of filter. Teflon® tape is recommended
and included. Teflon is a registered trademark of DuPont.
• Do not install in direct sunlight.
• Installation must comply with existing state or local plumbing codes.
For Use and Care questions call: GE Answer Center® 800.626.2000
GENERAL ELECTRIC COMPANY, Appliance Park, Louisville, KY 40225
GE SmartWater
INSTALLATION INSTRUCTIONS
GE Model GXIT Filter
SPECIFICATIONS
Service
Service
Flow rate
Life
0.5 gpm 2000 gal. or 6 months
(1.9 lpm)
(7571 liters)
INSTALLATION PRECAUTIONS
Part No. 215C1001P013
(8-99 JR)
1
OPTIONAL TOOLS FOR INSTALLATION
• a file
• sandpaper
System tested and certified by NSF
International against ANSI/NSF Std. 42
for the reduction of chlorine(Class 1),
and taste and odor.
Pressure
25–125 psi
(172–862 kPa)
Pub. No. 49-50026-1
Max.
Temp.
100° F.
(38° C.)

Publicidad

loading

Resumen de contenidos para GE SmartWater GXIT

  • Página 1 INSTALLATION INSTRUCTIONS GE Model GXIT Filter Your new GE icemaker water filter comes complete with all the necessary hardware for installation. Each filter gives you up to six months of great-tasting water. Filter should be changed after six months of use.
  • Página 2 GE. also have other rights which vary from state to state. — Liability on the part of GE under this or any other warranty for any indirect or consequential damage. — Products that are used for commercial or industrial...
  • Página 3 INSTRUCCIONES PARA LA INSTALACION FILTRO GE modelo GXIT Su nuevo filtro de agua GE para fábrica de hielo se surte completo e incluye todos los accesorios necesarios para la instalación. Cada filtro le brindará agua de excelente sabor hasta por seis meses.
  • Página 4 GE. y usted puede tener también otros derechos que varían —La responsabilidad de parte de GE, bajo esta o cualquier otra de un estado a otro. garantía por cualquier daño indirecto o consecuencial.