6. Connect two halves of the suction tube.
(See Figure 4)
Figure 4
NOTE: For shorter drums/tanks use only top
portion of suction tube.
7.
Connect suction tube to pump inlet. (See Figure 5)
Figure 5
Suction
Tube
8. Lift pump and insert into drum. Attach using the
swivel nut mounted on the pump. (See Figure 6)
Figure 6
Swivel
Nut
9. Attach hose and hand tighten to elbow. Tighten with
adjustable wrench. (See Figure 7)
Figure 7
PAGE 2 OF 9
ASSEMBLY CONTINUED
10. Attach the other end of the hose to the fuel nozzle.
Tighten with adjustable wrench. (See Figure 8)
11. Using wire
connecting
adapter, attach
power cord to
the pump motor.
(See Figure 9)
12. For better
access to motor
wiring, unscrew
side panel.
(See Figure 10)
13. Connect power
cord clamps to
a 12V battery
(not included).
(See Figure 11)
Figure 9
Figure 10
Figure 11
WARNING! Use caution when connecting
clamps to battery.
Figure 8
Side
Panel
0621 IH-7193