General Information; Key To Symbols; Qualified Personnel; Improper Use - Madas JVAP/NA Manual Del Usuario

1.0 - GENERAL INFORMATION

This manual shows you how to safely install, operate and use the device.
The instructions for use ALWAYS need to be available in the facility where the device is installed.
ATTENTION: installation/wiring/maintenance need to be carried out by qualified staff (as explained
in section 1.3) using appropriate personal protective equipment (PPE).
For any information pertaining to installation/wiring/maintenance or in any case problems that cannot be solved with the
instructions, contact the manufacturer by using the address and phone numbers provided on the last page.
1.1 - DESCRIPTION
Automatic venting solenoid valves for burners and gas appliances. They open when not powered, they close when powered
electrically.
They can be supplied (depending on the model) with CPI SWITCH (Closed Position Indicator) or OPI SWITCH (Open Position
Indicator). Further information regarding the CPI/OPI SWITCH is available in 6.0.
Reference standards: EN 16304 - EN 13611 - EN 60079-0-7-14-15-18-31.

1.2 - KEY TO SYMBOLS

DANGER: In the event
of non compliance, this
may cause damage to
property.

1.3 - QUALIFIED PERSONNEL

These are people who:
• Are familiar with product installation, assembly, commissioning and maintenance;
• Know the regulations in force in the region or country pertaining to installation and safety;
• Are trained on first aid.
1.4 - USING NON-ORIGINAL SPARE PARTS
• To perform maintenance or change spare parts (e.g. coil, etc.) ONLY manufacturer-recommended parts can be used. Using
different parts not only voids the product warranty, but might impair correct operation.
• The manufacturer is not liable for malfunctions caused by unauthorised tampering or use of non-original spare parts.

1.5 - IMPROPER USE

• The product must only be used for the purpose it was built for.
• It is not allowed to use fluids other than those expressly stated.
• The technical data set forth on the rating plate must not, under any circumstances, be exceeded. The end user or installer
is in charge of implementing proper systems to protect the device, which ensure that the maximum pressure indicated on
the rating plate is not exceeded.
• The manufacturer is not responsible for any damage caused by improper use of the device.
JVAP/NA - JVAP-1-3-6/NA - JVA-1-3-6/NA
DANGER: In the event of non
compliance, this may cause damage to
property, as well as harming people and/
or pets.
10
Madas Technical Manual - 1|1.7J - REV. 0 of 1
ATTENTION: Attention
is drawn to the technical
details intended for
qualified personnel.
Aug 2019
st