Instructions For Installing The Bluetooth Module - VIERLING VIT-A2 Instrucciones Para El Montaje

Instructions for installing the Bluetooth module

For use with a PDA, it is possible to retrofit the VIT-A2 DSL Tester with
a Bluetooth module. Proceed as follows to install the module:
1. Switch off the device by putting the switch on the front of the housing
into the "Off / Line Test" position. Also disconnect everything that is
plugged into the device.
2. Place the DSL tester with the
bottom of the housing facing
upwards on a table. Loosen the
four screws as shown in the figure
using a Philips screwdriver.
VIT-A2 - 70299.212 - 1.0 – 20060602
VIERLING
11