DeWalt D25981 Traducido De Las Instrucciones Originales página 21

4. Pull on the chisel to check if it is properly locked. The
hammering function requires the chisel to be able to move
axially several centimetres when locked in the tool holder.
To remove a chisel pull back the retainer
out of the tool holder.

WARNING: Always wear gloves when you change
accessories. The exposed metal parts on the tool and
accessory may become extremely hot during operation.
OPERATION
Instructions for Use

WARNING: Always observe the safety instructions and
applicable regulations.

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from power
source before making any adjustments or removing/
installing attachments or accessories. Be sure the
trigger switch is in the OFF position. An accidental start-up
can cause injury.

WARNING:
• Be aware of the location of pipework and wiring.
• Apply a pressure of approximately
20–30 kg to the tool. Excessive force does not speed
up chiselling but decreases tool performance and may
shorten tool life.
Proper Hand Position (Fig. A, B)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on each side handle
Switching On and Off (Fig. A)
To run the tool, press the on/off switch
To stop the tool, release the switch.
Demolition, Chasing and Channelling (Fig. A–F)
1. Select the appropriate chisel and clean its shank.
2. Insert the chisel and check whether it is properly locked.
3. Hold the tool using both handles
now runs in continuous operation.
MAINTENANCE
Your D WALT power tool has been designed to operate
e
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from power
source before making any adjustments or removing/
installing attachments or accessories. Be sure the
trigger switch is in the OFF position. An accidental start-up
can cause injury.
3 and pull the chisel
.
2
1 .
2 and turn on. The tool
Lubrication
Your power tool requires no additional lubrication.
Cleaning

WARNING: Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and around
the air vents. Wear approved eye protection and approved
dust mask when performing this procedure.

WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.
Optional Accessories

WARNING: Since accessories, other than those offered
by D WALT, have not been tested with this product, use
e
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.

WARNING: These chisels can be reground only a limited
number of times. If in doubt, contact your dealer for
recommendations.

WARNING: Ensure that the cutting edge does not show
discolouration caused by too much pressure. This may
impair the hardness of the accessory.
Accessory Maintenance
Accessory maintenance at the right time guarantees optimal
results in application and a long and efficient accessory life.
Grind the chisels on grinding discs. Refer to figure G for the
appropriate angles of the following chisels:
spade-shaped chisel
14
cold chisel
15
pointed chisel
16
Consult your dealer for further information on the
appropriate accessories.
Protecting the Environment
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can
be recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.
EngLIsh
WALT recommended
e
19