Check Blades; Sharpen And Replace Blades - TRAPP TR 600 Manual De Instrucciones

Check Blades

To assure good operation of the
equipment, frequently check whether
blades are in good condition, sharp and
screws are properly secured. To inspect
blades:
Stop the machine.
✔
Remove tractor ignition key and
✔
disassemble cardan.
Remove shredder cover screw.
✔
Slowly open cover to full opening.
✔
Turn disk and check the status of each
✔
blade.

Sharpen and Replace Blades

A good performance of the shredder
usually depends on how sharp blades are.
Blades are reversible and have two cutting
edges to be used before sharpening or
replacement. To disassemble blades:
Repeat procedures in item "Check
✔
Blades".
Turn disk until blade screws are
✔
accessible.
Loosen securing screws (A) and
✔
remove blade (B).
Turn blade 180° to use the good
✔
cutting edge.
Replace screws and washers. Tighten
✔
with a torque wrench according to
table "Torque Specifications".
Repeat the operation for remaining
✔
blades.
A
A
If both edges of the blade are worn,
sharpen them. If they are entirely worn or
damaged, replace them. Get in touch with
the TRAPP nearest Technical Assistance.
75
ENGLISH
B
B