Philips Solarium HB405/01 Manual De Instrucciones página 7

- Only use these protective goggles when you tan with a Philips tanning appliance. Do not use
them for other purposes.
- The protective goggles comply with protection class II according to directive 89/686/EEC.
6 Check the distance between your body and the tanning appliance.
- During tanning, the distance between the UV filter and the part of the body to be tanned must
be at least 60cm. (Fig. 2)
- Use the measuring tape to check the distance.
7 Switch on the appliance by setting the timer to the required tanning time (Fig. 3).
Note: For the correct tanning times, see section 'Tanning sessions: how often and how long?'
When the set time has elapsed, the timer automatically switches off the appliance.
,
- If you want to tan more parts of your body successively, you can set a new time before the set
time has elapsed.
- By setting the timer again before the set time has elapsed, you avoid the 3-minute waiting time
which is necessary to allow the tanning lamp to cool down.
8 Always unplug the appliance after use.
Tip: Keep track of the overall number of sessions you have had on a piece of paper.
cleaning
Always unplug the appliance and let it cool down before you clean it.
Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone
to clean the appliance.
1 Clean the outside of the appliance with a damp cloth.
Do not let water run into the appliance.
 Clean the UV filter with a soft cloth sprinkled with some methylated spirits.
3 Clean the protective goggles with a moist cloth.
Storage
1 Unplug the appliance.
 Let the appliance cool down for 15 minutes before you store it.
3 Wind the cord round the cord storage facility on the back of the appliance (Fig. 4).
replacement
lamp
The light emitted by the tanning lamp becomes less bright in time (i.e. after a few years in case of
normal use). When this happens, you notice a decrease in the tanning capacity. You can solve this
problem by setting a slightly longer tanning time or by having the tanning lamp replaced.
Always have the tanning lamp replaced by a service centre authorised by Philips. Only they have
the knowledge and skills required for this job and the original spare parts for your appliance.
UV filter
Never use this appliance when the UV filter is broken, damaged or missing.
Always have the UV filter replaced right away when it is damaged or broken.
Always have the UV filter replaced by a service centre authorised by Philips. Only they have the
knowledge and skills required for this job and the original spare parts for your face tanner.
EngliSH
7