PROZIS QUAY Manual Del Usuario página 5

EN
Notes:
- Please connect the USB wall adapter to a 5V/3A or 9V/2A output to
optimize the charging efficiency up to 10 W.
- A Qi-enabled smartphone will be charged first and the power bank will
be charged once the Qi-enabled smartphone has been fully charged.
- When attached to the dock, the USB output will be automatically
switched off. It will only be possible to function with wireless charging.
- An override function will be activated to switch off the battery in the
case of excess heat, voltage fluctuation or circuit abnormalities.
2. Power bank
Remove the power bank from the charging dock.
Press and hold the ON/OFF
button for 1 second to activate it.
The wireless charging LED
indicator light will flash blue
for 1 second and stay green
continuously when the charging
function is ready.
Place the back of the Qi-enabled
smartphone on the wireless
charging power bank.
8
The Wireless Charging LED indicator light will turn blue
when the charging function is ready.
3. Charging the smartphone by cable
Use a proper USB cable to connect your smartphone
through a USB output.
Once the smartphone is charging, the wireless charging
LED indicator light will switch on and hold for 2s, then will
automatic switch off while charging the device. Press the
ON/OFF button to check the battery of the power bank.
Note: To charge your Qi-enabled
smartphone, please disconnect the
smartphone connected via USB
output and follow the steps in the
section "Charging a Qi-enabled
smartphone".
EN
Onput 2
Onput 1
9