Troubleshooting - Toolson TS6000PRO Manual Del Usuario

Troubleshooting

Problem Possible Cause
Saw blade gets loose Fastening nut tightened insufficiently
after turning off the
motor
Motor does not start a)
b)
c)
No motor output turns Overload by dull saw blade, thermoprotection
off automatically is triggered
a) Burns on the a)
cutting surface
b) with longitudinal b)
cuts
c) with cross cuts c)
Fastening nut tightened insufficiently
Extension cable defect
Connections on the motor or switch defect
Wrong saw blade
Longitudinal stop not parallel
Slide carriage not parallel
Help
Tighten fastening nut, right-handed thread
a) Check the mains fuse.
b) See "Electrical Connection" in the operating
manual
c) Have it checked by an electrician
Insert a sharpened saw blade; motor can be turned
on again after the cooling period
a) Insert a sharpened saw blade
b) Insert saw blade with 20 or 28 teeth for
longitudinal cuts
c) Exchange the longitudinal stop