Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Steps
Locate the plastic bolt cover from the driver side and
use a screwdriver to lift it.
6
Remove driver side taillight assembly
8
Install license plate bracket with supplied foam pad on rear
bumper. Tighten bolts with supplied Allen wrench.
10
NOTE: Actual application may vary slightly from illustrations.
In the left rear corner, remove the cover to access the taillight bolt.
Use a Torx T40 bit to remove.
7
Pull the red clip out. Push the black clip down then unplug
the light wiring harness from the taillight.
9
Install license plate and LED lights (2) onto license bracket top two
holes. Tighten the nut on LED light
11
Page 3 of 5
post.("Use Caution" - Do not
twist light housing.)
Publicidad
Tabla de contenido
