To Set The Static Correction Level - Petsafe WORKLIGHT Manual Del Usuario

Contact the Customer Care Center at 1-800-732-2677 or visit our web
site at www.petsafe.net to locate a retailer near you.

To Set the Static Correction Level

Read all steps before attempting to set the Static Correction
Level.
1. Remove the clear plastic cover with the edge of the Test
Light Tool to expose the Correction Level Button (D).
2. With the battery installed, press the Correction Level
Button and release when the Receiver LED Indicator Light
lights up (E).
3. The Receiver LED Indicator Light will emit a series of
flashes representing the Static Correction Level.
4. Increase the Static Correction Level by pressing and
releasing the Correction Level Button within 5 seconds of
the previous series of flashes.
5. After setting the Static Correction Level, replace the
cover to protect the Correction Level Button. The Static
Correction levels increase in strength from 1 to 4.
Pushing the Correction Level Button while the Receiver
Collar is on level 4 will cause the Receiver Collar to
www.petsafe.net
D
E
11