Test Light Instructions - Petsafe WORKLIGHT Manual Del Usuario

Test Light Instructions

1. Make sure the Receiver Collar battery is
properly installed. Set the Correction Level to
2 or above.
2. Hold the Test Light Contacts to the Contact
Points (I).
3. Walk toward the Boundary
Zone holding the Receiver
collar at your pet's neck level (J)
until the Test Light flashes (K).
Save Test Light for future testing.
Note: If the Test Light does not flash, install a new battery and re-test.
If Test Light still does not flash, contact the Customer Care Center at
1-800-732-2677.
J
www.petsafe.net
I
K
Pet
Area
21