Residual Risks - Ryobi R4SD Traducción De Las Instrucciones Originales

Take it to an authorised serviceman
for electrical check to determine if the
charger is in good working order.
Do not disassemble charger. Take it
to an authorised serviceman when
service or repair is required. Incorrect
reassembly may result in a risk of
electric shock or fire.
Unplug charger from outlet before
attempting any maintenance or
cleaning to reduce the risk of electric
shock.
Disconnect charger from the power
supply when not in use. This will
reduce the risk of electric shock or
damage to the charger if metal items
should fall into the opening. It also will
help prevent damage to the charger
during a power surge.
Risk of electric shock. Do not
touch uninsulated portion of output
connector or uninsulated battery
terminal.
BATTERY SAFETY WARNINGS
Li-ion
Do not dispose of used battery packs
in the household refuse or by burning
them. To ensure proper disposal of
waste battery packs and protect the
environment, hand over old battery
packs to your Ryobi distributor.
Segregate electronic waste properly
by removing integrated battery packs
from the main unit before disposal.
Hand them over to applicable
2
collection points.
To remove the integrated battery
pack: Separate the housing shells
from one another by removing the
screws. Disconnect the battery pack
from the circuit and remove.
NOTE: When opened, the product is
no longer reusable or serviceable and
should be disposed of properly.
Before removing the battery pack
from the power tool, switch on the
product until the battery pack is fully
discharged.
Ensure that the battery pack to be
disposed of cannot come in contact
with batteries, other battery packs,
or conductive materials by protecting
exposed connectors with insulating,
non-conductive caps or tape.
Never charge a damaged battery
pack.

RESIDUAL RISKS

Even when the product is used as
prescribed, it is still impossible to
completely eliminate certain residual risk
factors. The following hazards may arise
and the operator should pay special
attention to avoid the following:
Damage to hearing caused by noise
Wear suitable hearing protection and
limit exposure.
Injury to the eyes
Wear protective eye shields or goggles
when using the product.
Injury caused by vibration
Limit exposure. Follow the instructions
in Risk Reduction.
Electric shock caused by contact with
English