Related Documents - Stafsjö D2G Instrucciones De Instalación Y Servicio

A) General
In this instruction a "knife gate valve" is shortly called "valve".
A1 Symbols
In this instruction notes and warnings are marked with symbols:
Danger / Warning
Points out a dangerous situation which may cause personal injuries or death.
XXXXX
Advice
Has to be respected.
Information
Information useful to follow.
If these notes and warnings are not respected by the user, dangerous situations may occur and may invalidate the
warranty of the manufacturer.
A2 Valve destination
Valve types D2G, HG, HL, HP, HX, JTV, MV, RKO, RKS, SLF, SLV, SLH, SLX, TV, XV and WB are destined – after
installation between flange(s) in a pipe system – to shut off, to open or to control the flow within the admissible
pressure/temperature limits, defined in data sheet on www.stafsjo.com.
The flow shall be without vibrations and/or pressure chocks. The surrounding environment should not imply any risk
to the valve. This also implies to explosive environment – except for valves classified for ATEX- area
accordingly.
Installation of the knife gate valve is preferred with the actuator in an upward position – except for RKO, RKS, JTV and
D2G.
At valve operation respect:
• The manufacturers declaration to EC directives,
• This original installation and service instruction which is supplied together with the valve.
If the valves are placed in any type of media or application that the valve material configuration is not suitable for,
Stafsjö cannot be held responsible for problems and incidents that may arise.
Stafsjö Valves AB does not accept any responsibility if this "Valve destination" is not observed.
A3

Related documents

Further information on the valves is available on www.stafsjo.com.
ds+valve type (i.e. ds-MV) = Data sheet with technical information (dimensions, material specification etc.)
mi+valve type (i.e. mi-MV) = Instructions for maintenance on each valve type.
sp+valve type (i.e. sp-MV) = Specify spare parts for each valve type.
acc+type of accessory (i.e. acc-SV) = Accessory for different types of valves. I.e solenoid valve.
Stafsjo_valve_specifications = Specification of parts and valve combinations.
and marked
Document: is-VALVE, 21-02-11 issue: 15