NORTH STATES 4913 Instrucciones página 4

Step 4
• Tighten both of the bottom tension nuts 4A by turning them clockwise at the same time 4B.
• Tighten both of the upper tension knobs 4C by turning them clockwise at the same time, so the gap
between the gate and upper right corner comes together, leave a .060" - .078" gap shown in figure 4D.
4A
gate frame
4C
• Use the wrenches provided to ease turning the tension knobs and nuts. Figure 4E, 4F.
4E
Note: When tightening, the distance between the 4 tension bolts should be equal as shown in figure 4G.
Operation
Opening the gate locking system (see Figure 5A):
1. Rotate the locking handle to the vertical position.
2. Depress the release button as shown.
3. Lift the door up until it swings freely.
4. Swing the door open in desired direction.
Closing and latching the gate (see Figure 5B):
1. Simply release the gate and allow it to swing closed (unless the Stay-Open feature is used).
2. To latch, rotate the locking handle to horizontal position, as shown in Figure 5B. This effectively "triple latches" the gate.
5A
4
Note: Verify proper gate installation by partially opening and releasing it.
The door will swing closed and double-latch automatically.
tighten inward
tension nuts
4F
3 4
2
1
4B
tighten inward
4D
.060" - .078"
4G
5B
1
To Close the gate by
switching the side part
of locking handle to
horizontal position.
(approx. the
width of a nickel)
distances should be equal
2
Page 4